StageDesigner

Inserting, L/R pair and truss magnet

How to insert a loudspeaker or device from the Sound library: with a click, as an L/R pair, or by dragging it onto the scene, where arrays and point-source loudspeakers snap to truss runs.

2 min read
Documentation contents ▾

You can insert any library item in three ways. The app picks the position by itself based on the equipment type, and the whole insert is a single undo step with an Undo message.

Ways to insert

ActionResult
The [+] button on the card or a double-click on the cardInserts the item at the first free position intended for its type
Insert in the expanded cardSame as [+]
Insert L/R pairTwo sets placed symmetrically on both sides of the stage (arrays, point-source loudspeakers, column speakers, subs)
Dragging the card onto the sceneThe item lands where you drop it; arrays and point-source loudspeakers snap to the truss

Where the equipment goes

  • Arrays and loudspeakers are placed relative to the stage and aim at the listening zone right away: the app sets the array angles or the tilt.
  • When there is a truss above the set position, the array is flown under its bottom chord.
  • Microphones go onto the stage, near its front edge.
  • Amplifiers, processors and receivers without a control room are placed in a row of racks next to the stage.

The message after inserting tells you where the set was placed, for example "on the truss" or with the trim height.

Truss magnet

While you drag an array or a point-source loudspeaker over a truss, the item snaps to the nearest run. Snapping works along the run: to a 0.25 m grid, nodes and the middle of the span. The array hangs under the bottom chord, with clearance for the shackle and sling.

Drag over a truss
Snap to the truss run
Alt+drag
No magnet (drop on the floor)
Shift+drag
No 0.25 m grid along the run

A set flown on a truss becomes a load on it: the structure statics count the mass of the set with its frame. A set with Flown mounting that does not hang on any project structure gets a note about the required rigging point with a capacity of at least the mass with frame plus 25 % margin for slings.

After inserting

You edit the selected set in the inspector: model, role, number of elements, mounting, angles, height, gain and delay. Details in the article Loudspeaker set in the inspector. A complete system with amplifier channels is faster to build with the wizard.

Did not find the answer?
Describe the problem and we will reply with a solution or add an article.