Cables are a separate layer in the scene. Each family has its own color, 400 V power has its own color and a thicker line, and wireless DMX a dotted line. The layer is not included in scene export, frame renders or presentation mode.
Showing and hiding
- Button in the top bar (layer group next to the image quality modes):
Show cabling/Hide cabling. When the project has no cables, the button is disabled with the description "no cables in the project". - Eye button on the Cabling panel toolbar:
Show cables in scene/Hide cables in scene.
Family filter
When the plan has more than one family, family chips with cable counts appear on the panel toolbar. The same chips and the Problems only toggle are in the legend above the scene while the Cabling panel is open. The filter applies to the 3D layer and the cable list; it is saved per project.
Selecting a cable
The cursor over a cable changes to a pointer and the cable is highlighted. Clicking selects the cable and opens its details in the Cabling panel. You can also pick a cable from the list in the Cables tab, from the ports in the device inspector or from the report.
Signal direction animation
A selected cable has an outline and pulses flowing along the route. The direction comes from the ports at the ends: from output to input. When both ports are bidirectional (network, intercom), every other pulse flows the opposite way. Without port data, the direction is taken from source to load, the way the cable was planned.
Deleting a device and its cables
When you delete a device from the scene, the cabling plan is cleaned up immediately:
- cables ending at the deleted device are removed,
- the load is removed from its circuit, and a circuit without loads is deleted,
- the fixture is removed from the DMX line chain and from the patch, and a line without fixtures is deleted,
- accessories (cable ramps, terminators) are recalculated.
The exception is locked items: a locked cable stays with the warning "no device at end A/B" and a Delete cable button, so you can connect it to a new device. Locked circuits and DMX lines also stay.
Moved equipment
With live routes on, cables follow the equipment (described in Cable routes). With them off, routes stay, and cables of devices moved by more than 0.5 m get the message "Route is outdated, the device has been moved" with a Recalculate route button.
