StageDesigner

LED screens and lighting in the plan

Stage screens on the floor plan with dimension labels and visibility zones, and fixtures on beams and stands: spreading fixtures along a run, fixture groups, and quick sets.

3 min read
Documentation contents ▾

The LED screens and Lighting sections show on the floor plan objects that live in the 3D scene. Changes made in these sections go to the scene right away, each as one undo step.

LED screens

Stage screens appear on the floor plan as surfaces; the modules of one LED screen merge into a single surface. The label gives the dimensions and the height of the bottom edge, and flown screens have a dashed line. Labels are placed without overlapping: along the screen, or offset with a leader line when space runs out.

A selected screen has its X and Z position and rotation in the inspector, and the readouts show the dimensions, the bottom edge, and the mounting method. The In scene list names all screens. You insert a new screen from the library in the section: drag it onto the plan, or set the position and dimensions and then click Insert into scene: ….

The visibility readouts (Seats in visibility zone, Outside zone, Bottom of screen blocked) and the Show visibility zones on plan switch help you position the screens for the room layout. You do not copy screens on the plan: you duplicate them in the 3D scene or with the screen wizard.

Lighting

The Lighting section (Stage group) covers fixtures on structure runs and on stands. The counter next to the section shows the number of such fixtures in the scene.

No structure

When the scene has no trusses, the section suggests a front truss over the stage: choose the Type (290 mm truss or 400 mm truss) and click Add front truss … m above stage. The length and height of the truss follow from the stage dimensions, so the light hits faces at an angle of about 45°.

Spread fixtures on a truss

  1. Click Spread fixtures on truss.
  2. Click a structure run on the plan or in the Structure runs list. To pick several runs, click them one after another.
  3. Choose the fixture Model, the Direction (Toward stage, Down, Toward audience, Symmetrical), and optionally Every other reversed.
  4. In the On the run group choose By: Count (pieces per run) or Spacing (every how many meters), plus Alignment (From nodes or From center) and Margin from nodes.
  5. Check the Fixtures, Weight with accessories, and Structure load readouts, then click Insert … fixtures.

Fixture groups

Fixtures inserted on a run form a parametric group in the Fixture groups list. A selected group shows the number of fixtures, the weight with accessories, and the structure utilization. In the Placement section you change the group’s count, spacing, and color, and in the DMX section the fixture mode and Manual addresses (universe, start address). Without manual addresses, cabling planning assigns the addresses along the truss.

Quick sets

The collapsed Quick sets group suggests typical layouts with a number of fixtures matched to the stage width; the Insert … button adds a set. Sets require a stage in the plan or a stage object in 3D.

DMX addressing and lines are described in the articles DMX addressing and cabling planning.

Did not find the answer?
Describe the problem and we will reply with a solution or add an article.