StageDesigner

Amplifiers, channels and sound cabling

How the app assigns amplifier channels by impedance, when channels or power run short, how it calculates loudspeaker cable losses, and how to plan the sound cabling.

3 min read
Documentation contents ▾

Passive sets need amplifier channels. The app assigns them automatically, checks impedance and power headroom, and calculates cable losses. You see the result on the System tab, in the set inspector and in the report.

Channel assignment

Elements are connected in parallel down to the minimum amplifier impedance (arrays usually 2–3 elements per channel, subs 1–2). A multi-way set driven by several channels (bi-amp over NL4, tri-amp over NL8) gets its channels in one amplifier. The Channels tile shows the needed and available channels, and the Amplifiers list shows the usage of each device.

System notes

NoteLevelFix
Not enough amplifier channels, or the free channels are scattered or too weakerrorAdd amplifier / Add amplifiers
Output load below the minimum amplifier impedanceerrorSplit across channels
Set without an amplifier channelcautionAdd amplifier
Channel power below the recommended headroom of 1.0–2.0 × the set AES ratinginfoChange the amplifier
Cable loss above 0.5 dBcautionLarger cross-section, amplifiers closer
Array with more elements than the class frame allowserrorReduce number of elements
Array angles outside the frame rangecautionSet angles
Set flown outside a structureinfoPlan a rigging point
No system processorinfoAdd processor
No mixercautionAdd mixer

Loudspeaker cable losses

For each cable the app calculates the loop resistance (2·ρ·L/A) and the loss in dB at the load impedance. The recommended loss is at most 0.5 dB. When it is higher, the note gives the cable, length, cross-section, loss and the recommended cross-section.

Before the cabling is planned, the app estimates cables as NL4 4 × 2.5 mm² in a straight line and warns for sets where the loss would exceed 0.5 dB. After the cables are planned, the actual route and cross-section from the plan are used.

Planning sound cabling

  1. On the System tab click Plan sound cabling.
  2. The app plans the audio and power cables; when the project already has a cabling plan, it only adds the missing routes.
  3. The message gives the number of new cables. The whole operation is a single undo step.
  4. You can check routes, cross-sections and power in the Cabling panel.

The sound system wizard runs the same planning when the Plan sound cabling and power switch is on. The plan, routes that avoid evacuation routes, and fixes are described in the article Cabling plan.

Power

The 1/3 power draw tile gives the indicative power draw of the system at typical drive levels. Active sets and amplifiers go into the cabling power balance and the project report.

Did not find the answer?
Describe the problem and we will reply with a solution or add an article.