StageDesigner

DMX patch: manual addresses, overlaps and splitting lines

How to change a fixture address by hand, recalculate addresses, split a line and fix DMX warnings.

3 min read
Documentation contents ▾

The patch is a list of fixtures with universe, start address and channel count. The planner proposes it together with the DMX lines, and you can change any address. The patch is in the DMX tab of the Cabling panel, in the Patch group.

Patch table

Columns: device (with mode name), line, universe, address, channel count. Rows are sorted by universe and address. The group description reminds you that the fixtures' DMX modes are examples and the channel footprint must be checked in the device manual.

Changing an address by hand

  1. Open the DMX tab in the Cabling panel.
  2. In the patch table, type the new address in the fixture's field. The field accepts values that keep the fixture within 512 channels.
  3. The address gets a padlock "Address set manually". It stays unchanged when addresses are recalculated.

If the new address overlaps another fixture in the same universe, the message "Overlaps: …" appears below the field, and the issue list shows an error with the Recalculate addresses fix.

Recalculate addresses

Recalculate addresses reassigns addresses on all lines without changing cables. Manual entries stay. The address overlap fix from the issue list may release the manual address of a conflicting fixture; the toast then says how many entries lost their manual address and whether any overlaps are left for a manual decision.

The Readable addresses toggle in the Patch group recalculates addresses immediately: on gives type blocks starting at full hundreds, off gives consecutive addresses.

Splitting a line

Split line next to a line in the table (or the fix on a warning) splits the chain in half. The second half gets a new universe, a separate source output and addresses from 1. The cable between the halves now starts at the source, and both lines end with a terminator. The button is inactive for a line with one fixture.

DMX warnings

WarningWhenFix
Line has too many devices (error)More than 32 devices on a line.Split line
Line too longTotal cable length of the line above 300 m.Split line
No terminatorLine without a 120 Ω DMX terminator at the end.none (add a terminator)
Universes from one output (error)Two universes come out of one DMX output.Add node
Universe has too many channels (error)Total channels or the end of the last fixture above 512.Recalculate addresses
Addresses overlap (error)The ranges of two fixtures in the same universe overlap.Recalculate addresses
Fixture in the wrong universe for its line (error)The fixture's address is in a different universe than the line it hangs on. It will not receive data.Recalculate DMX
Fixtures without DMX controlThe fixture cannot be reached by DMX cables from a node or console.Connect automatically
Did not find the answer?
Describe the problem and we will reply with a solution or add an article.